W arranty Term s ........................................17 W arranty Conditions ......................................17 W arranty Exclusions ....................................... 19 O H& S Disclaim er ........................................19 IN STALLATIO N RECO RD ..................................... 20 Page 2 of 20 rev. 01/09/21 UserManual_2021-Enviroheat.indd 2 1/09/2021 11:47:38 PM...
Im proper disposal is hazardous to your health and the environm ent. You can obtain further inform ation on how to recycle thus product from your m unicipality, your waste m anagem ent service or the Enviroheat dealer where you purchased the appliance.
FU N CTIO N IN G & PRIN CIPLE O F O PERATIO N Your Enviroheat system is called a heat pum p because it collects heat from the am bient air and “pum ps” it into the water in the storage vessel. This is done in m uch the sam e way that an air conditioner rem oves heat from a room and expels it to the outside air.
SPECIFICATIO N S Model 200EH1-14 250EH1-15 Tank volum e 195L 246L Rated voltage/ frequency 220V~240V/50Hz 220V~240V/50Hz Tank rated pressure 0.7MPa 0.7MPa Corrosion protection Magnesium rod Magnesium rod Insulation Protection Rating IPX4 IPX4 Typeof system Monobloc air source heat pum p CO P@7 ℃...
O utlet Safety Valve Hot W ater O utlet Inlet for Cold W ater/D rain O utlet Air O utlet Air Inlet M odel 200EH1-14 1,692 250EH1-15 1275 1,987 Page 6 of 20 rev. 01/09/21 UserManual_2021-Enviroheat.indd 6 1/09/2021 11:47:39 PM...
CAUTION Your Enviroheat system em its very low noise level however there are certain tim es of the day where any noise m ay be objectionable. This is especially the case if the system is located near a bedroom and is running while the occupants are sleeping. It is highly recom m ended that the system be program m ed to run when noise is not objectionable, for exam ple between 5am and 9pm , or that the system be located away from bedroom s rev.
Installation Dim ensions ~400m m ~50m m Air O utlet Air Inlet D isplay Page 8 of 20 rev. 01/09/21 UserManual_2021-Enviroheat.indd 8 1/09/2021 11:47:39 PM...
The installation shall conform to the Plum bing Code of Australia (PCA). The following standards and regulations m ust be taken into account when planning the installation of the Enviroheat water heater system . • AS/NZS 3500.4.2 Notational plum bing and drainage code hot water supply system s – acceptable solutions.
If hydrogen is discharged through the tap, it will probably m ake an unusual noise as with air escaping. Do not place hands or any part of your body beneath the tap during this procedure. Page 10 of 20 rev. 01/09/21 UserManual_2021-Enviroheat.indd 10 1/09/2021 11:47:39 PM...
ELECTRICAL CO N N ECTIO N S Your Enviroheat system is equipped with a 10 Am p plug and cord that enables connection to power via a weatherproof power outlet. CAUTION Electrical Protection Precautions For safe perform ance this water heater is f tted with a therm ostat and an over tem perature cut-out. These devices should not be tam pered w ith or rem oved.
7 days and raise the tem perature to 63°C. This display gives you an indication of how m uch hot water capacity is available in your system . Page 12 of 20 rev. 01/09/21 UserManual_2021-Enviroheat.indd 12 1/09/2021 11:47:41 PM...
You have now set the START and STO P tim e and tim e of day. Whilst in ECO m ode, the system will only run between the program m ed tim es. Whilst the running noise level of the Enviroheat system is quite low , it is not advisable to allow the unit to run during the night when am bient noise levels are low .
W ater discharge through the pressure relief valve All Enviroheat heat pum p water heaters have two pressure valves located within the system conf guration. The cold water expansion control valve (ECV), located in the cold water supply pipe, m ay release a sm all am ount of water from tim e to tim e during the heating cycle of the system . The water discharge is water expanding due to the heating process.
CAUTION The Enviroheat heat pum p hot water system should be drained and f ushed every f ve years during a m ajor service of the unit. 1. Turn off and isolate the power supply to the electrical elem ent.
Hot Water Solutions For after sales service: 0800 497 658 For sales or new product: 0800 497 658 info@enviroheat.nz https://enviroheat.nz Head Office Enviroheat NZ 3d Tait Place Rosedale, Auckland 0632 Page 16 of 20 rev. 01/09/21 UserManual_2021-Enviroheat.indd 16 1/09/2021 11:47:41 PM...
The initial point of contact for all W arranty claim s is the Enviroheat Dealer from whom the Product was purchased. All warranty claim s m ust be reported to Enviroheat no later than 14 days from the date the fault is reported to the Enviroheat Dealer. All term s...
LESS DEPRECIATIO N, upon its return. Enviroheat or an Enviroheat Dealer will provide labour to resolve warranty issues during the warranty period. Repair service shall be available at the purchaser’s location. Enviroheat will determ ine how and where repair services are provided, and the purchaser m ay, at Enviroheat’s reasonablecost, be required to deliver product to an authorised location.
O H&S D isclaim er Enviroheat and its Authorised Dealers work with and recom m end various installation and plum bing com panies to install, test and certify correct operation of solar hot water system s or the Product. Enviroheat is a supplier of system s only.
Please com plete this page as a record of the installation details for your reference to determ ine when the system is due for service or if a warranty m atter should arise. Return the blue copy of this Installation record to the address below and the pink copy to the Dealer/Installer. Enviroheat NZ 3d Tait Place Rosedale, Auckland 0632 ............................................
Need help?
Do you have a question about the 200EH1-14 and is the answer not in the manual?
Questions and answers