Table of Contents
Advertisement
Hookups (cont'd)
9
DVD/VCR
to TV only
Simplest
connection
using
only the supplied
black RF coaxial
cable
This connection
will let you use the features
of both theVCR
and the DVD
player.
Antenna
or
Cable
TV
signa[
In Jack
(on back of TV)
example only
Black RF coaxia[
cable (suppJied)
2
3
Disconnect
the antenna
or CableTV
signal from yourTV
and
connect
it to the ANT-IN
(Antenna
In) jack of your DVD/VCR.
Connect
the
supplied
black
RF coaxial
cable
to the ANT-OUT
(Antenna
Out)
jack
on the
back
of the
DVD/VCR
and
to the
ANTENNA
IN jack
on theTV.
The ANTENNA
IN jack on theTV
may be
labelled TV IN, RF IN, 75_Q (ohm)
or ANT-IN.
See your
TV owner's
manual
for
assistance.
Plug in the power
cord of yourTV.Turn
on theTV
and set it to
channel
3 or 4.
Plug in the power
cord of the DVD/VCR.You
are ready
to turn on
the DVD/VCR.
Go to page 16 before
turning
it on.
The DVD/VCR's
output channel is 3 when you purchase it. So, set yourTV
to
channel 3 when the DVD/VCR
is new.
If you cannot use channel 3 at your TV, you can change the DVD/VCR's
output
channel to channel 4.To do so, pressVCR
to put the DVD/VCR
inVCR mode.
VCR light will be on the front of the DVD/VCR.
Insert a videotape and press
PLAY I_ to start playback. During
playback,
press and hold (VCR)
PLAY I_ on the front of the DVD/VCR
for 3-5 seconds. Each time you
do this, the DVD/VCR's
output channel switches between
3 and 4, and the
selected channel number appears on the display panel. Change yourTV
to
channel 3 or 4 accordingly. (You cannot change the DVD/VCR's
output
channel
while adjusting tracldng manually. Press STOP • to stop playback and cancel
manual tracldng, then press PLAY I_ to resume playing and change the output
channel.)
There is not a channel 3/4 switch on the DVD/VCR
(as customary with most
VCRs).
Advertisement
Table of Contents
