Technics RS-TR474 Operating Instructions Manual page 13

(Refer to the right side of this page.)
Press <{ or > to begin recor-
ding, and play the source to
[el] be recorded.
p>: To begin record:ng from the for-
ward side.
~"&: To begin recording from the
reverse side.
{nA mrt = on
WU gp... gs HULL
ORD Serre re
>!
i
IMuminates
When recording or both sides of the
tape, be sure to press the > button.
RS-TR474 only
When recording without using the ATC function, step 3 is un-
necessary.
To temporarily stop recording
Press once again to resume recording.
To stop recording
re Press Hi.
RS-TR474 only
To cancel the ATC settings
{While ATC settings are in progress]
= Press MB.
[After ATC settings have been completed]
age Press ATC.
If the "M_ indicator begins to flash quickly while the ATC set-
§ings are in progress, i indicates that the seltings cannct be
made for ore of the following reasors:
About the selection of the Dolby NR type
The Dotby NR effect can be obtained by using the same type of
Dolby NR during both recording and piayback. Refer to the fellow-
Ing table wher: selecting the type (either B ar C).
Use this type when the deck on which the tape
Type B will be piayed back is eau'pped with only type B
Dolby NR
Use this type when the deck on which the tape |
will be played back is equipped with type C |
Dolby NR. (for exampie, when this unit is also go-
ing to be used to play bacx the tape.)
Type C
(Refer *o "About the Dolby noise-reduction system" on page 8.)
About the balance adjustment
While playing a monaural source, adjust so that the left and right
level indications on the level meter are the same.
ulti
aonan!
LE Ld wey
ag
| naa =
i i
Level meter
About the recording level adjustment
If the recording level is too high, there will be distortion in the
recorded sounds, and if it is too low, the hiss noise inherent to
recording tapes will become noticeable.
in order to make high-quality recordings, use the REC LEVEL con-
trol to adjust so that highest values of the input level indicated by
the level meter do not exceed the standard recording level (the
number indicated in parentheses) for the tape belng used.
1
Non,
Cot LU
a
420044 PLAY
>
mia Ay =
ulitti o
ny
Normal or CrO, tape (0) ea tape (+2)
The tape has reached the leader tape.
The tape is severely damaged.
«The cassette deck's heads are severely dirty.
*The tape is a non-standard type. such as a metal! tape which
has no tape type identification hole in the cassette.
elf the cassette holder is opened after the ATC settings have
been completed, the settings will be canceled.
When making the ATC settings midway along a tape, provide a
silent interval at least 2 seconds long after the last track prior to
where the settings will begin.
13