Choosing The Right Cookware; Using The Device - Veripart VPVKP4ZF1 User Manual

1
4.3.

CHOOSING THE RIGHT COOKWARE

NOTICE!
RISK OF DAMAGE TO THE DEVICE.
• Never use damaged cookware or cookware with notched edges. Damaged cookware can scratch the glass surface.
• Never slide cookware across the glass surface. Sliding cookware can scratch the glass surface.
• Always use the appliance with cast iron, enamel or stainless steel cookware suitable for induction.
Choose a pan suitable for induction. Pans suitable for induction are marked with the following symbol:
The following types of pans are not suitable for induction:
• Pans made of aluminium, ceramic, copper, glass or Pyrex.
• Hollow-bottomed pans.
• Pans smaller than 10 cm in diameter.
• Pans greater than 22 cm in diameter.
4.4.

USING THE DEVICE

WARNING!
FIRE HAZARD FROM OIL AND GREASE. Never leave the appliance unattended while in use. Cooking with fat or oil can be
dangerous and can lead to fire. Never extinguish a fire with water. Switch off the appliance and cover the flames with a lid or
fire blanket.
ELECTROCUTION HAZARD DUE TO SHORT CIRCUIT.
• Never use the device if a part is damaged or faulty. Replace a damaged or faulty device immediately. Disconnect the
power cable from the wall socket and contact customer service.
• Never use the device in a damp space, like a bathroom, or nearby a bath, shower or swimming pool.
• Only use the power cable installed on the appliance from the factory. Do not change the power cable.
FIRE HAZARD DUE TO OVERHEATING.
• Always continuously monitor the cooking process while using the appliance.
• Do not store any objects on the appliance.
2 2
• Do not heat empty pans or thin-bottomed pans on the cooking zones.
• Never use the appliance to heat a room.
• Never use the appliance if the glass surface is cracked. Turn the appliance off.
CAUTION!
RISK OF BURNS DUE TO HEAT. Never place metal objects such as knives, forks, spoons and lids on the cooking zone. Metal
objects can become hot.
4.4.1. TURNING ON THE APPLIANCE
1. Press and hold the power button for 3 seconds to turn the appliance on.
The display shows -. The appliance emits an audible signal.
2. Place a pan on the cooking zone. Make sure the cooking zone and the bottom of the pan are clean and dry.
After one minute of inactivity, the appliance automatically goes into standby mode. The LED on/off button goes off. The display
goes off.
4.4.2. ADJUSTING THE POWER SETTING
1. Press the control button of a cooking zone of your choice.
2. Swipe the power setting control to set the power setting or press the plus or minus button to set the power setting directly to
the maximum or minimum power setting.
The cooking zone heats up. The display shows the selected power setting.
The display shows the no-pan-detected symbol when the pan is removed from the cooking zone.
28
.