Table of Contents
Advertisement
Operating Manual Reprint
To stop Dual Watch:
Press the ACC button.
Operation will revert to the channel to which the
CH knob is set.
Talk Around
Press the ACC button to activate the Talk Around fea-
ture when you are operating on duplex channel sys-
tems (separate receive and transmit frequencies, uti-
lizing a "repeater" station). The Talk Around feature
allows you to bypass the repeater station and talk di-
rectly to a station that is nearby. This feature has no
effect when you are operating on "Simplex" channels,
where the receive and transmit frequencies are already
the same.
Note that your dealer may have made provision for
"Talk Around" channels by programming "repeater"
and "Talk Around" frequencies on two adjacent chan-
nels. If so, the ACC key may be used for one of the
other Pre-Programmed Functions.
Call/Reset
When the 2-tone selective calling unit is installed, press
the ACC button to silence the receiver and reset for
another call, when a communication is finished.
Speed Dial
Your Dealer may have pre-programmed Auto-Dial
telephone number memories into your radio.
To dial a number, just press the Dealer-assigned ACC
button for Speed Dialing. The DTMF tones sent dur-
ing the dialing sequence will be heard in the speaker.
TX Save Off
Press the ACC button to disable the Transmit Battery
Saver, if you are operating in a location where high
power is almost always needed.
The Transmit Battery Saver helps extend battery life
by reducing transmit power when a very strong sig-
nal from an apparently nearby station is being received.
Under some circumstances, though, your hand-held
radio may not be heard well at the other end of the
communication path, and high power may be neces-
sary at all times.
4
ACC 1
Activates an optional Unit (module) while the ACC
button is held depressed.
When you release the ACC button, the optional Unit
will be disabled.
For further details, contact your VERTEX STANDARD
dealer.
ACC 2
Toggles the optional Unit "on" or "off" whenever you
press the ACC button.
For example, when the optional "FVP-25" voice en-
cryption unit is installed, press the ACC button mo-
mentarily to disable the voice encryption feature tem-
porarily.
Press the ACC button again to re-enable the voice en-
cryption feature.
Accessories & Options
Accessories & Options
Accessories & Options
Accessories & Options
Accessories & Options
FNB-V57
7.2 V 1100 mAh Ni-Cd Battery Pack
FNB-V57IS 7.2 V 1100 mAh Ni-Cd Intrinsically safe Battery
FBA-25A
Alkaline Battery Case (6 AA)
NC-76B
120 VAC Wall Charger
NC-76C
230-240 VAC Wall Charger
VAC-6400 6-Unit Multi charger
VAC-400B 120 VAC Desktop Rapid Charger
VAC-400C 230-240 VAC Desktop Rapid Charger
VCM-1
Mobile Mounting Bracket for VAC-400
MH-45
Speaker/Microphone
B4B
MH-37
Earpiece/Microphone
A4B
VC-25
VOX Headset
FVP-25
Encryption /DTMF Page Unit
VTP-50
VX-Trunk Unit
CT-42
PC-Programming Cable (CT-28 + CT-29)
CT-27
Cloning Cable (Set-to-Set Cloning)
FTT-17
16 keypad for VX-Trunk (VTP-50 required)
LCC-210
Leather Case
Advertisement
Table of Contents
