Roland GK-3B Owner's Manual page 12

Attaching the GK-3B to the Bass
Sag na aR SA TR Ts SSS Pd a OTR ES TL OS
* Afterwards, you will need to adjust the pickup sensitivity when connecting to GK devices. However, you may find that
the sensitivity level on the GK device is too high. In such instances, you may be able to correct the problem by widening
the clearance between the strings and the pickup. Carry out Steps 1 through 8 again to lower the Pickup height slightly.
ii ee EE
e Clearance Gauge
_ The divided pickup height must be adjusted so that the clearance between each string and
_ the divided pickup is 1.5 mm (0.06") when the highest fret is fingered.
The clearance gauge supplied with the GK-3B is 1.5 mm thick; place the gauge between the
strings and the divided pickup as shown in the figure below, then check and adjust the height.
E Attaching the Pickup with Screws
* If mounting the GK-3B with screws, ensure a holes and the pickup as shown in the
body at the position where the pickup is positioned. a
i ! PESA with the screws.
onl
æ
Determine the position for attaching
the pickup. When you have determined
the positioning, mark the position of
the holes at each end of the pickup on
the bass's body.
eau)
2. Remove the strings from the bass.
3. Using a drill or similar means, open
pilot holes where the attachment
screws are to go in.
* If the pilot holes are not made in the correct
positions, then the pickup will not be attached in the |
correct position either. Use extra care when drilling | Pilot Hole
the pilot holes. E aA
12