Receiving Data (Bulk Load)
You can receive data from another AP-700, or receive AP-
700 data previously stored on a sequencer. Such data
reception is called a "bulk load."
<How to Make the Connections>
Receiving Data Stored on a Sequencer
Connect the two devices as shown below. Set the AP-700
to the same MIDI channel that was used when the data
was saved on the sequencer.
©
oop0e
aA
ao
mnoaed
oo Soop
oD aqD
RaqQe
on ago
Bo
mont
MIDI IN
* Refer to the sequencer's manual if you need instructions on
how to operate the sequencer.
<How fo Receive the Data>
The AP-700 can receive SysEx messages from an external
MIDI device at any time.
The following message appears on the display while
receiving bulk data.
DATA RECEIVING
26