Table of Contents
Advertisement
21. Maintenance Check
TOSHIBA strives to ensure consistent product quality from manufacturing to installation
in order to ensure that the customers receive products with the best possible safety and
reliability characteristics. The customer is responsible for maintaining and operating the
products after purchase.
TOSHIBA representatives provide after-sales service for products out of warranty on a
pay-for-service basis.
21.1 Maintenance Checks to Be Carried Out by Customers
21.1.1 Cleaning the system
CAUTION:
CAUTION:
Do not use solvents (such as paint thinner or benzine) or abrasive
cleansers for cleaning the system. These substances may cause
deterioration in the monitor.
(1) Cleaning the transducer
Clean, disinfect, and sterilize the transducer referring to the operation manual
provided with the transducer.
(2) Cleaning the transducer holder
(a) Wipe off any stains on the transducer holder using a soft dry cloth.
(b) If it is difficult to remove stains, wipe off stains using a soft cloth moistened
with mild detergent and then tightly wrung out.
(3) Cleaning the transducer connector
(a) Wipe off any stains on the transducer connector using a soft dry cloth.
(b) If it is difficult to remove stains, wipe off stains using a soft cloth moistened
with water and then tightly wrung out.
1. Before cleaning the system, be sure to disconnect the
system power cable from the outlet of the facility.
If the system has been defective, an electric shock may
occur.
2. Do not spill or spray liquids such as water onto the system
or peripheral units. If a liquid such as water enters the
system or peripheral units, an electric shock may occur.
No. 2B730-973EN*D
21-1
Advertisement
Table of Contents
