Toshiba famio XG SSA-530A Operation Manual page 17

Diagnostic ultrasound system
Table of Contents

Advertisement

CAUTION:
(2) Turn OFF the system power before connecting or
(3) When a HUB is used, turn ON the system power only after
(4) Do not press the RESET switch when the system is operating
8. In normal diagnostic ultrasound mode, there is no danger of a low-
temperature burn; however, keeping the transducer on the same
region of the patient may cause such a burn.
9. Clean the ECG cable regularly.
(1) Do not allow clips to wet. The ECG is not displayed correctly.
(2) Do not soak the connector in the water.
(3) Do not use solvents (such as paint thinner, benzine, or alcohol)
10. Cleaning the LCD monitor
(1) Do not hit or apply strong pressure to the LCD surface during
(2) Never use a stiff or hard cloth to clean the LCD monitor.
(3) If stains on the LCD surface are difficult to remove, wipe it
(4) Do not attempt to clean the LCD monitor with organic solvents
(5) Do not allow liquid droplets to remain on the LCD surface.
11. If there is any possibility of secondary infection, cover the entire
system with a sterile cover. To obtain a sterile cover, contact your
TOSHIBA representative.
disconnecting the cable from the ETHERNET terminal. If the
cable is connected or disconnected with the system power ON,
the system may not operate properly.
tuning ON the power to the HUB.
normally. Data loss or damage to the system may result.
Wipe the connector with dry cloth only.
The water may enter the connector inside, possibly resulting in
failure.
for cleaning the ECG cable.
cleaning. Doing so may damage the monitor.
Doing so may damage the monitor cover or LCD surface.
gently with a soft cloth slightly moistened with water.
Detergents or chemical agents should not be used because
they may damage the monitor.
such as benzine, paint thinner, and alcohol or abrasive
cleaners.
Such agents may damage the monitor cover or LCD surface.
Also, do not use mild detergent to clean the LCD surface.
The droplets may cause small stains when they dry or may
enter the LCD surface, possibly resulting in failure.
No. 2B730-973EN*D
S-6

Advertisement

Table of Contents
loading

Table of Contents