Firmware Upgrade - Creality CV-01 PRO User Manual

Dear customer,
Thank you for purchasing our product. Please read the following instructions carefully
before first use and keep this user manual for future reference. Pay particular attention
to the safety instructions. If you have any questions or comments about the device,
please contact the customer line.
www.alza.co.uk/kontakt
✆ +44 (0)203 514 4411
Importer Alza.cz a.s., Jankovcova 1522/53, Holešovice, 170 00 Praha 7, www.alza.cz

Firmware Upgrade

Please login the official website https://www.creality.com/download, switch the language
and select the relevant printer and model and download the required firmware, you can
use it after the installation is finished.
Notes
For the purpose of engraving or cutting with a laser engraving machine, allow the
•
workpiece to be exposed to the high-density laser beam emitted by the laser
engraving machine. The workpiece may be subject to gasification without
combustion as it is pretty hot on the surface. On the other hand, most
workpieces are essentially combustible, which may be ignited, leading to open
fire and consequently to the machine breakdown and environmental
contamination.
It is prohibited to store the machine in areas close to combustible and explosive
•
substances, volatile solvents or source of heat. Instead, store it in a well-
ventilated, cool and dust-free place.
Make sure that only the specific attached power cord rather than other similar
•
power cords are used during installation.
Ensure to run the laser at 0°C-35°C. Operation at sub-zero temperature is
•
prohibited. It is prohibited to run the machine under wet environment or in
thunderstorm weather
If the user needs to strengthen the protection during the use or maintenance,
•
you shall wear a protective suit with a compliant and laser protective effect.
Switch off the machine if it is offline for an extended period of time, and unplug
•
the power cord.
It is prohibited to come in contact with electronic areas with hands or other tools
•
when the machine is connected to power supply
Touching any moving parts and laser module while the machine is running is
•
prohibited.
3