Step 4 - Install Oven; Step 5 - Make Electrical Connection - Sharp Drawer SWB3085HS Installation Instructions Manual

STEP 4 - INSTALL OVEN

WARNING
EXCESSIVE WEIGHT HAZARD
Use two or more people to move and install oven.
Failure to do so can result in back or other injury.
1 Using two or more people, grasp the ceiling of the oven cavity and
lift the unit onto a lifting dolly, with the rear of the unit facing
the cutout opening.
NOTE: The surface must be able to support 300 lb.
2 Cover the glass front of the unit with a moving blanket to protect
the glass from scratches and breakage.
3 Lift the dolly until it is even with the cutout opening.
4 Feed the flexible electrical supply conduit from the oven to the
junction box.
STEP 5 - MAKE ELECTRICAL
CONNECTION
To properly install your oven, you must determine the type of
electrical connection you will be using and follow the instructions
provided for it here.
DIRECT WIRE
ELECTRICAL SHOCK HAZARD
Disconnect power before servicing.
Improper connection of aluminum house wiring and copper
appliance leads can result in an electrical hazard or re. If the
home has aluminum wiring, only use connectors designed and
CUL listed for joining copper to aluminum and precisely follow
the manufacturer's recommended procedure. Aluminum-to-
Copper connections must conform with local codes.
Use 8 gauge copper or aluminum wire.
Electrically ground oven.
Failure to do so can result in death, fire or electrical shock.
Be sure your appliance is properly installed and grounded by a
qualified technician. Ask your dealer to recommend a qualified
technician or an authorized repair service.
This oven is manufactured with a neutral (white) power supply wire
and a cabinet connected green (or bare) ground wire twisted together.
After making sure that the power has been turned off, connect the
flexible conduit from the oven to the junction box using a CUL
listed conduit connector. The Grounded Neutral and Ungrounded
Neutral Graphics on the following pages and the instructions
provided, present the most common way of connecting ovens. Your
local codes and ordinances, of course, take precedence over these
instructions. Complete electrical connections according to local
codes and ordinances.
1 Disconnect power.
2 Remove junction box cover.
3 Install a CUL listed or CSA approved conduit connector to the
junction box.
4 Route the flexible electrical supply conduit from the oven to the
junction box through a CUL listed or CSA approved conduit
connector.
5 Tighten screws on conduit connector.
7
WARNING