Installation Requirements; Location Requirements - Sharp Drawer SWB3085HS Installation Instructions Manual

INSTALLATION REQUIREMENTS

TOOLS AND PARTS
Gather the required tools before starting installation. Read and follow
the instructions provided with any tools listed here.
ALL INSTALLATIONS
TOOLS NEEDED:
• Measuring Tape
• Straightedge
• Pencil
• Phillips Screwdriver
• Level
• Wire Cutters and Wire Stripper
• Hand or Sabre Saw
• 1" Hole Saw
• Cordless Drill and Drill Bit
• Safety Gloves and Goggles
• Volt Meter (0-250VAC)
• Lifting Dolly
• Moving Blanket
PARTS NEEDED:
• CUL Listed Conduit Connector
• CUL Listed Wire Connectors
PARTS PROVIDED:
• #8- 7 / " Screws (8)
8
TECHNICAL DATA
OVEN
Sharp Smart Convection Wall Oven with
Microwave Drawer Oven
™

LOCATION REQUIREMENTS

IMPORTANT: Observe all governing codes and ordinances.
• Cabinet opening dimensions that are shown must be used. Given
dimensions provide minimum clearance with oven.
• Recessed installation area must provide complete enclosure
around the recessed portion of the oven.
• The oven support surface must be solid, level and flush with the
bottom of the cabinet cutout.
• The oven support surface must be able to support 300 lb.
• Grounded electrical supply is required. See ELECTRICAL
REQUIREMENTS on page 5.
NOTE: It is recommended that the junction box be located in the
adjacent right or left cabinet.
IMPORTANT: To avoid damage to your cabinets, check with your
builder or cabinet supplier to make sure that the materials used will
not discolor, delaminate or sustain other damage. This oven has
been designed in accordance with the requirements of CUL and
complies with the maximum allowable wood cabinet temperatures
of 194°F (90°C).
ELECTRICAL RATINGS AND MAXIMUM CONNECTED LOAD
MODEL
SWB3085HS
2
@ 240 VOLTS 60 HZ
40 AMP 950 WATTS (CUL)