Disturbance
detergent or
Fabric softener drips
the cuff and
collects on the door
or in the cuff fold.
Spin result is
not satisfactory
lend. The laundry is
too wet/too damp.
detergent residue
de on the damp
laundry.
Cause and troubleshooting
Too much detergent/fabric softener in the detergent
drawer.
When dispensing liquid detergent and fabric
▶
softener, pay attention to the marking in the
detergent drawer and do not dispense over it.
Low spin speed is set.
Set a higher spin speed for the next wash cycle.
▶
Start the programCentrifuge / Essorage .
▶
Drain pipe or water drain hose is blocked.
Clean the drain pipe and water drain hose.
▶
Drain pipe or water drain hose is kinked or pinched.
Make sure the drain pipe and water drain hose are
▶
not kinked or pinched.
Unbalance control system stopped spinning due to
uneven distribution of laundry.
Redistribute the laundry in the drum.
▶
A notice:If possible, place large and small items of
laundry together in the drum. Different sized items of
laundry are distributed better when spinning.
Start the programCentrifuge / Essorage .
▶
Unbalance control system compensates for unbalance
by reducing the spin speed.
Redistribute the laundry in the drum.
▶
A notice:If possible, place large and small items of
laundry together in the drum. Different sized items of
laundry are distributed better when spinning.
Start the programCentrifuge / Essorage .
▶
Detergents can contain water-insoluble substances
that are deposited on the laundry.
Start the programSpoelen / Rinçage.
▶
Troubleshootingde
47