Getting Started; Setup - VTech vt2417 Owner's Manual

Connecting power to Base Unit
Plug the AC power adapter into an electrical outlet, and the DC connector into the
bottom of the Base Unit.
Installation of Battery Pack in Handset
Follow the steps below:
1. Remove the battery cover by pressing
on the indent and sliding downward.
2. Place the new battery pack in the
Handset with the metal contacts aligned
with the charge contacts in the battery
compartment.
3. Replace the battery cover by sliding it
upwards.
4. If the new battery pack is not already
charged, place the Handset in the Base
Unit, and allow it to charge for 12 hours.
After the initial charge, a maintenance
charge of 8 hours should be sufficient.
4

Setup