Table of Contents
Advertisement
Setup
Connecting to Phone Line
Before connecting the phone line, make sure to properly charge the
battery for at least 12 hours.
Plug one end of the telephone line cord into the jack on the bottom of the
Base Unit. Plug the other end of this cord into the wall jack.
Checking for Dial Tone
After the battery is charged press ON on the Handset. The phone icon
will appear on the Handset display, and you will hear dial tone. If not, see
In Case of Difficulty.
Tone/Pulse Selection
• With the Handset in the idle (OFF) mode, press MENU.
• Use
• Use
• You'll hear a confirmation beep.
NOTE: Your 2621 is preset for TONE dialing.
CAUTION: Use only the power supply provided with your 2621.
IMPORTANT:
For best performance the 2621
should be installed as follows:
In an elevated location, in the center of
the room, with no obstructions nearby.
In a location that is away from other
electrical appliances such as microwave
ovens,
personal
televisions.
Scroll to TONE/PULSE, then press OK.
Scroll to TONE or PULSE; press OK.
computers,
or
9
Advertisement
Table of Contents
