Operating The Unit; Setting Examples - Boss Fuzz FZ-3 Owner's Manual

OPERATING THE UNIT
1 When you have made the necessary 2 Depress the pedal switch to turn the
connections, set the knobs as shown in effect on. (Make sure the CHECK indica-
the illustration. tor lights.)
3 Adjust the depth of the Fuzz effect
using the FUZZ knob.
10
1 Loosen the thumbscrew at the front of the
pedal, then lift the pedal upwards to open
the unit.
* The thumbscrew can be left in the pedal
while changing the battery.
2 Remove the old battery from the battery
housing, and remove the snap cord con¬
nected to it.
3 Connect the snap cord to the new battery,
and place the battery inside the battery
housing.
* Be sure to carefully observe the battery's
polarity (+ versus -)■
4 SI ip the coil spring onto the spring baseon
the back of the pedal, then close the
pedal.
* Carefully avoid getting the snap cord
caught in the coil spring.
5 Finally, insert the thumbscrew into the
guide bush hole and fasten it securely.
Adjust the tone using the TONE knob. 5 Adjust the LEVEL knob so that the level
of the sound obtained when the effect is
on is equal to that obtained when it is
SETTING EXAMPLES
For Single-Coil Guitar For Humbacking Guitar
13