Special Area - IDEC WB1F Series User Manual

1 Overview
2. 3

Special Area

With the special memory area starting address as a header, the following functions shown in the table below are assigned
to the data memory.By setting the corresponding bit of the correspoding address to "1", each function can be performed.
The WB1F performs the requested function, and then performs zero clear of the special area.
The zero clear after the function is executed targets not only the corresponding bit of the corresponding address, but the
special area entirely.
Address
bit
(OFFSET)
0 PLC Connection end
1 - 7 Reserved
0 8 Start barcode reading
9 Stop barcode reading
10 - 15 Reserved
0 OK Output OFF
1 OK Output ON
2 NG Output OFF
3 NG Output ON
PWM Output OFF
4
(When successful settings)
PWM Output ON
5
(When successful settings)
PWM Output OFF
6
(When failure settings)
PWM Output ON
1
7
(When failure settings)
8 Indicator LED (Red) OFF
9 Indicator LED (Red) ON
10 Indicator LED (Orange) OFF
11 Indicator LED (Orange) ON
12 Indicator LED (Green) OFF
13 Indicator LED (Green) ON
14 Reserved
15 Reserved
2 0-15 Reserved
3 0-15 Reserved
2 Operation Specifications
Function
Ends the PLC Connection.
Starts barcode reading
Stops barcode reading.
Stops the OK Output.
Starts the OK Output (the operation logic and operation time
follows the setting value.)
Stops the NG Output.
Starts the NG Output (the operation logic and operation time
follows the setting value.)
Stops the PWM Output.
Starts the PWM Output. (Frequency, duration, and duty follow
the setting values.)
Stops the PWM Output.
Starts the PWM Output. (Frequency, duration, and duty follow
the setting values.)
Sets the Indicator LED (Red) to the OFF state.
Sets the Indicator LED (Red) to the ON state (the lighting pat-
tern and the lighting time follows the setting value.)
Sets the Indicator LED (Orange) to OFF state.
Sets the Indicator LED (Orange) to ON state (the lighting pat-
tern and the lighting time follows the setting value.)
Sets the Indicator LED (Green) to OFF state.
Sets the Indicator LED (Green) to ON state (the lighting pattern
and the lighting time follows the setting value.)
2-2
3 Setting and Wiring
Contents
4 Menu Sheet
Special Area