Operating Instructions; Maintenance - Klutch 114923 Owner's Manual

1. Check reel for correct operation by slowly pulling out hose or cable. A "clicking" noise will be
heard every half revolution of the drum.
2. To latch the reel, pull out the hose or cable and allow it to retract after hearing the first, second or
third "click."
3. To unlatch, slowly pull out the hose or cable until the "clicking" noise stops, and then let hose or
cable retract until the hose or bumper block rests against the cable guide.
4. If overloaded, the current protector will cut off automatically, unplug all appliances from the cord
and push the button to restore power.
5. Periodically check the hose condition for wear or damage, and check the swivel fitting for leakage.
Replace any worn, damaged, or leaking parts.
Note: To avoid damage to the reel, always hold on to the cable while it is rewinding.
Do not allow the hose to automatically retract in an uncontrolled way as the hose may whip
around and cause damage to property or personal injury.
Do not open the spring cover. Behind these covers are the main rewind springs. Removal of this
cover by untrained persons can be very dangerous as the spring may come loose, unwind violently,
and cause serious personal injury.
Maintain your tool. It is recommended that the general condition of any tool be examined before it is
used. Keep your tool in good repair by adopting a program of conscientious repair and maintenance in
accordance with the recommended procedures found in this manual. Keep all cutting tools sharp and
clean. Properly maintained cutting tools with sharp cutting edges are less likely to bind and are easier
to control. Keep handles dry, clean, and free from oil and grease.
1. Make sure the cable is in proper working order and that the insulation is not cut or worn as this
could represent a hazard and jeopardize operation.
2. Clean the cable with a cloth dipped in warm water to remove dirt or deposits and ensure correct
rewinding.
3. Do not use detergents or solvents, which could damage the reel.
4. If it is necessary to perform maintenance on the electrical, mechanical parts of the reel, or to
replace the cable, contact an authorized service center.

Operating Instructions

Maintenance

Page 10 of 16