Table of Contents
Advertisement
Quick Links
30" Standard Gas Range
Understand Operator's Manual. Save These Instructions For Future Reference.
Installation Manual
Cook Options
Bake
Broil Hi/Lo
455-4603 / 455-4604 / 455-4605
INSTALLATION MANUAL
To Reduce The Risk Of Injury, User Must Read And
Oven Settings
88:88
Timer / On/o
Set / Clock
Start
Oven / Light Cook / Time Delay Time
Cancel/ O
Lock Controls
Automatic Oven
Hold 3 Seconds
Advertisement
Table of Contents
Related Manuals for Criterion 455-4603
Summary of Contents for Criterion 455-4603
- Page 1 Oven / Light Cook / Time Delay Time Broil Hi/Lo Cancel/ O Lock Controls Automatic Oven Hold 3 Seconds 455-4603 / 455-4604 / 455-4605 INSTALLATION MANUAL To Reduce The Risk Of Injury, User Must Read And Understand Operator’s Manual. Save These Instructions For Future Reference.
-
Page 2: Table Of Contents
TABLE OF CONTENTS RANGE SAFETY INFORMATION RANGE SAFETY . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . FOR YOUR SAFETY AND THE SAFETY OF OTHERS, PLEASE READ ALL SAFETY INSTRUCTIONS BEFORE INSTALLING THIS APPLIANCE. -
Page 3: Range Safety
RANGE SAFETY INFORMATION (continued) INSTALLATION REQUIREMENTS ANTI-TIP BRACKET FLOOR/ WALL MOUNTING: The range will not tip during normal use. However, the range can tip if you apply too much force or weight to the open door without the anti-tip bracket fastened down properly. TIP OVER HAZARD •... - Page 4 INSTALLATION REQUIREMENTS (continued) INSTALLATION REQUIREMENTS (continued) Tools/Parts Needed: Tape Measure Hammer 15/16" Combination Wrench Flathead Screwdriver Pipe Wrench 1/4" Drive Ratchet Phillips Screwdriver Wrench or Pliers 3/8" Nut Driver Level Marker or Pencil 1/8" (3.2 mm) drill bit (for wood floors) Hand or Electric Drill Gas Line Thread Tape or Gas Pipe Joint Compound For LP/Natural Gas Conversions...
-
Page 5: Electrical Connection
INSTALLATION REQUIREMENTS (continued) INSTALLATION REQUIREMENTS (continued) CABINET DIMENSIONS ELECTRICAL REQUIREMENTS Cabinet opening dimensions shown are for • 110/120V, 60HZ, properly grounded circuit protected by a 15-amp or 20-amp circuit 26" (66.0 cm) countertop depth, 24" (61.0 breaker or time delay fuse. It is recommended that a separate circuit serving only this cm) base cabinet depth and 36"... - Page 6 INSTALLATION REQUIREMENTS (continued) INSTALLATION REQUIREMENTS (continued) TYPE OF GAS Gas Pressure Regulator: The gas pressure regulator supplied with this range must be used. The inlet pressure to the Natural Gas: regulator should be as follows for proper operation: This range is design-certified by UL International for use with Natural gas or, after proper conversion, for use with LP gas.
-
Page 7: Installation Instructions
INSTALLATION INSTRUCTIONS INSTALLATION INSTRUCTIONS (continued) MAKE GAS CONNECTION Completing the Connection: 1. Open the manual shutoff valve in the A. Closed Valve gas supply EXPLOSION HAZARD line. The valve is open when the handle is parallel • Use a new CSA International approved gas supply line. to the gas pipe. -
Page 8: Electronic Ignition System
INSTALLATION INSTRUCTIONS (continued) INSTALLATION INSTRUCTIONS (continued) ELECTRONIC IGNITION SYSTEM How to Adjust the Standard Burner: The flame can be adjusted using the Initial Lighting and Gas Flame Adjustments: adjustment screw in the center of the A. Control Knob Stem valve stem. The valve stem is located •... -
Page 9: Level Range
INSTALLATION INSTRUCTIONS (continued) GAS CONVERSIONS HOW TO REINSTALL THE OVEN DOOR: Gas conversions from Natural Gas to LP Gas or from LP Gas to Natural Gas must be done by a qualified installer. 1. To reinstall the oven door, insert both hanger arms of the oven door into the range. -
Page 10: Natural Gas To Lp Gas
GAS CONVERSIONS (continued) GAS CONVERSIONS (continued) How to Convert the Surface Burner. How to Convert the Oven Burner. NATURAL GAS TO LP GAS NATURAL GAS TO LP GAS 1. Make sure the power is disconnected from the appliance and the manual gas shutoff The Oven Burner Orifice is located at the rear of the broiler inside. - Page 11 NOTES GAS CONVERSIONS (continued) 6. Remove the bracket (G) of the gas pipe connector (H) on the back of the oven by remov- ing two 4 x 8 mm screws and two 4 x 12 mm screws using a Phillips head screwdriver, and then gently pull out the gas pipe connector (I).
- Page 12 NOTES NOTES...
- Page 13 30" Standard Gas Range User Manual 455-4603 / 455-4604 / 455-4605...
Need help?
Do you have a question about the 455-4603 and is the answer not in the manual?
Questions and answers