Panasonic Lumix S-R24105 Service Training Manual page 20

6.2.2.5. Installation of Lens P.C.B. with Mount Contact Unit
6.2.2.6. Installation of the Rear Frame Unit
Screw (E)
Screw (D)
1. Install Rear Frame Unit to Ring Mount Base Unit
with adjusting the rotational phase so as to match
below 3 point of A, B and C.
2. Tighten screw (D) by using the torque driver with specified torque.
When reusing Ring Mount Base Unit,
tighten with a torque of 12~13Ncm.
(
3 screws should be tightened with same torque
1. Install Lens P.C.B. with Mount Contact Unit to
Ring Mount Base Unit so that the screw of the Lens P.C.B. match.
2. Tighten Screw (E) Gently.
- Screw(E) × 3
3. Insert FPC to connector of Lens P.C.B.
24mm
- Screw(D) × 3
- Torque : 14±0.5Ncm
SILVER
Screw(E)
Connectors
A
B
4
BLACK
)
C