1. Manuals
  2. Brands
  3. SOUNDLIGHT Manuals
  4. Media Converter
  5. 3613PWM-H Mk5 RDM
  6. Operating manual

SOUNDLIGHT 3613PWM-H Mk5 RDM Operating Manual

Dmx / pwm decoder
Hide thumbs
1
2
3
4
5
6
7
8
9
Table of Contents

Advertisement

Quick Links

Download this manual
last updated: 17-08-11
OPERATING MANUAL
DMX / PWM Decoder 3613PWM-H Mk5 RDM
(C) SOUNDLIGHT 1996-2017
*
ALL RIGHTS RESERVED
*
NO PART OF THIS MANUAL
MAY BE REPRODUCED, DUPLICATED OR USED COMMERCIALLY WITHOUT THE PRIOR
WRITTEN CONSENT OF THE OWNER
*
ALL STATEMENTS WITHIN THIS MANUAL HAVE
BEEN CHECKED CAREFULLY AND ARE BELIEVED TO BE ACCURATE, HOWEVER SOUND-
LIGHT DOES NOT ASSUME ANY RESPONSIBILITY FOR ERRORS OR OMISSIONS. * THE
USER HAS TO CHECK THE SUITABILITY OF THE EQUIPMENT FOR THE INTENDED USE.
SOUNDLIGHT EXPRESSLY EXCLUDES ANY RESPONSIBILITY FOR DAMAGES - DIRECT OR
INDIRECT - WHICH MAY OCCUR DUE TO MISUSE, UNPROPER INSTALLATION, WRONG
OPERATING CONDITIONS AND NON-COMPLIANCE TO THE INSTRUMENT'S INSTRU-
CTIONS, AS WELL AS IGNORANCE OF EXISTING SAFETY REGULATIONS.
SOUNDLIGHT
Bennigser Str. 1 D-30974 Wennigsen Tel. 05045-912 93-11
The DMX Company

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 3613PWM-H Mk5 RDM and is the answer not in the manual?

Questions and answers

Related Manuals for SOUNDLIGHT 3613PWM-H Mk5 RDM

Summary of Contents for SOUNDLIGHT 3613PWM-H Mk5 RDM

  • Page 1 LIGHT DOES NOT ASSUME ANY RESPONSIBILITY FOR ERRORS OR OMISSIONS. * THE USER HAS TO CHECK THE SUITABILITY OF THE EQUIPMENT FOR THE INTENDED USE. SOUNDLIGHT EXPRESSLY EXCLUDES ANY RESPONSIBILITY FOR DAMAGES - DIRECT OR INDIRECT - WHICH MAY OCCUR DUE TO MISUSE, UNPROPER INSTALLATION, WRONG OPERATING CONDITIONS AND NON-COMPLIANCE TO THE INSTRUMENT'S INSTRU- CTIONS, AS WELL AS IGNORANCE OF EXISTING SAFETY REGULATIONS.
  • Page 2 Thank you for choosing a SOUNDLIGHT device. The SOUNDLIGHT DMX PWM Converter 3613PWM-H is an intelligent converter accepting drive signals according to USITT DMX-512/1990, DIN 56930-2, ANSI E1-11 DMX512A and ANSI E1-20 DMX RDM. The DMX signal is converted to a PWM output signal to drive low voltage incandescent lamps, proportional valves or voltage driven LED arrays.
  • Page 3 UNPACKING Please unpack carefully and check that all items are intact. When leaving our factory, the interface has been in good condition. In case of damage during transport please notify the carrier immediate- When unpacking, you should identify these items: the interface 3613PWM-H this manual Please note that a start address programming adaptor (3000P) is NOT included with DIN rail mount...

  • Page 4: Signal Indicators

    blue Common GND white CH 3: Drive Output - blue Common GND white CH 3: Drive Output - DMX Data Input grey GND, Screen blue DMX Drive Signal - DMX Drive Signal + DMX Data Output grey GND, Screen blue DMX Drive Signal - DMX Drive Signal + IMPORTANT NOTICE: Outputs are not short circuit protected and must be fused ex-...

  • Page 5: Dip Switches

    The decoder can be operated with or without start address board connected. Please note that me- chanical switches become disengaged and the respective settings are overridden when pro- gramming is done via RDM. To re-engage the switches, set the hundreds position to „9“ temporari- ly and wait for a programming cycle to complete.

  • Page 6: Wiring Instructions

    Common LED terminal is the positive pin of the supply voltage ("Common Anode"). As high cur- rents are present, carefully check the wiring instructions and use sufficiant wire gauges. Outputs are not short circuit protected and must be fused externally. WIRING INSTRUCTIONS Please note: At full load, the total operating current is in excess of the rating of a single output cage clamp con-...

  • Page 7: Technical Data

    TECHNICAL DATA Dimensions: 86mm (W) x 93mm (D) x 66mm (H), width 5TE (units) Power supply: 24V DC DMX IN: 1 Unit Load DMX OUT: fed-thru DMX data slots: 3(4) PWM Out: 24V pulse signal 0%-100% PWM resolution: 12Bit PWM characteristic quasi-logarithmic / linear Max.

  • Page 8: Fcc Statement

    The warranty is limited to repair or exchange of the hardware product; no further liability is assumed. SOUNDLIGHT is not responsible for damages or for loss of data, sales or profit which arise from usage or breakdown of the hardware product. In...
  • Page 9 Electronic devices must not be placed in domestic waste. Consult your lo- cal authorities to find the nearest collection point of used electric and electronic devi- ces. SOUNDLIGHT is a WEEE registered company (Reg No. DE58883929). ACCESSORIES To set the DMX start address and change the operating parameters, a DMX RDM controller or a start address board is needed.

Table of Contents