JVC GR-DVL300 Instructions Manual page 61

Indications
TAPE!
TAPE END
DIFFERENT
FORMATTED TAPE
SET DATE/TIME!
LENS CAP
A. DUB ERROR!
A. DUB ERROR!
<CANNOT DUB
ON AN LP RECORDED
TAPE>
<CANNOT DUB
ON A 16BIT
RECORDING>
<CHECK TAPE'S ERASE
PROTECTION SWITCH>
INSERT ERROR !
INSERT ERROR !
<CANNOT EDIT
ON AN LP RECORDED
TAPE>
<CHECK TAPE'S ERASE
PROTECTION SWITCH>
COPYING FAILED
E01 — E06
UNIT IN SAFEGUARD
MODE REMOVE AND
REATTACH BATTERY
Appears if a tape is not loaded when the Recording Start/Stop Button or
SNAPSHOT Button is pressed while the Power Switch is set to "
" ".
Appears when the tape ends during recording or playback.
Appears if a tape in another format is loaded.
● Appears when the date/time is not set.
● Appears when the built-in clock battery runs out and the
previously set date/time is erased. Consult your nearest JVC dealer
for replacement.
Appears for 5 seconds after power is turned on if the lens cap is attached.
● Appears if Audio Dubbing is attempted on a blank portion of a tape.
● Appears if Audio Dubbing is attempted on a tape recorded in the LP
mode.
● Appears if Audio Dubbing is attempted on a tape recorded in 16-bit
audio.
● Appears if A. DUB (e) on the remote control is pressed when the erase
protection tab is set to "SAVE".
● Appears if Insert Editing is attempted on a blank portion of a tape.
● Appears if Insert Editing is attempted on a tape recorded in the LP mode.
● Appears if INSERT (w) on the remote control is pressed when the erase
protection tab is set to "SAVE".
Appears if dubbing of copyguarded signals is attempted while this
camcorder is being used as a recorder.
The error indications (E01 — E06) show what type of malfunction has
occured. When an error indication appears, the camcorder turns off
automatically. Remove the power supply (battery, etc.) and wait a few
minutes for the indication to clear. When it does, you can resume using the
camcorder. If the indication remains, consult your nearest JVC dealer.
Function
61
EN
" or
( pg. 15)
( pg. 11)