Voxson Voxtrack GPS300 Troubleshooting Manual

VOXTRACK GPS Troubleshooting Quick Reference Guide
Symptom
My GPS turns off when I turn my
vehicle's ignition off.
My GPS unit's internal battery is not
charging.
My GPS won't turn on (blank screen).
My GPS screen is plain white, has
vertical lines, or is not functioning
normally.
My GPS is displaying an error
"Your current map is erased or
damaged"
when I click on the Navigation button.
The map on the screen does not match
my location.
My unit is not giving me any voice
instructions for turns.
symptoms not described above, please contact Voxson Customer Support on 1300 889 990
Please refer to the following guide prior to contacting customer support.
Cause
Internal battery is switched off or
flat.
Internal battery is switched off or
there is no power to charger
cable.
There is no power to the device
Internal battery is too flat for
device to power up correctly.
SD Card in the front of the unit is
not inserted correctly.
GPS position fix has not yet been
acquired.
Volume is set too low.
If the above solutions do not resolve your unit's symptoms; or if your GPS exhibits
Ensure that power switch on back of unit is in the ON position and allow to charge.
Check power switch on back of the unit is in the ON position. Check that the green
light on the charger cable is on. Confirm that the vehicle's cigarette lighter socket
has power and replace the fuse in the charger cable if necessary.
Check that:
- the power switch on the back of the device is in the ON position
- the charger cable is connected to the device
- the cigarette lighter socket has power to it and that the green light on the charger
cable is on
If the above are all fine, try resetting the unit by the following method:
1. Disconnect the charger cable from device
2. Place power switch to OFF position
3. Reconnect charger cable and wait for device to turn on (main menu will be
displayed)
4. Place power switch back into ON position
Reset the unit using the method described above. Once the unit is turned back on,
leave the charger connected to charge the internal battery.
Remove and reinsert the SD card. Push the card in until you feel a click, then release.
The edge of the card should not protrude past the front of the device. If it does,
remove and reinsert the SD card again.
Ensure that unit has unobstructed view of the sky. Remain stationary until position fix is
obtained (this will be indicated by the absence of the cross on the green arrow in the
centre of screen). This process may take up to 15 minutes for an initial position fix
(cold start).
Increase the volume by pressing the up arrow button on the front of the device
several times.
Solution