Table of Contents
Advertisement
en Troubleshooting
Fault
Insufficient cleaning.
The spin result is not
satisfactory. The laun-
dry is too wet/too
damp.
Detergent residue on
the damp washing.
52
Cause and troubleshooting
Check whether the detergent used is suitable.
1.
→ "Detergents and care products", Page 31
Drain the dispenser.
2.
→ "Cleaning the detergent drawer", Page 39
Clean the dispenser.
3.
Refill the dispenser.
4.
→ "Filling the dispensers", Page 35
A low spin speed is selected.
The next time you run a wash cycle, set a higher
▶
spin speed.
Start the
programme.
▶
Fácil is activated.
Select the programmes that are suitable for the
▶
type of fabric.
Drain pipe or water outlet hose is blocked.
Clean the drain pipe and the water outlet hose.
▶
Drain pipe or water drain hose is caught or jammed.
Ensure that the drain pipe and water drain hose are
▶
not kinked or trapped.
The unbalanced load detection system has interrupted
the spin cycle because the laundry is unevenly distrib-
uted.
Redistribute the laundry in the drum.
▶
Note: Where possible, mix large and small items in
the drum. Different sized items of laundry distribute
themselves better during the spin cycle.
Start the
programme.
▶
Unbalance load detection system is using a reduced
spin speed to eliminate an unbalance.
Redistribute the laundry in the drum.
▶
Note: Where possible, mix large and small items in
the drum. Different sized items of laundry distribute
themselves better during the spin cycle.
Start the
programme.
▶
Detergents may contain water-insoluble substances
that deposit on the laundry.
Start the
programme.
▶
Unsuitable detergent added to the dispenser of the in-
telligent dosing system.
Advertisement
Table of Contents
