Table of Contents
Advertisement
en
Eliminating minor faults yourself
Before you call customer service:
Please check whether you can eliminate the fault yourself based on the following
information.
Customer service will charge you for advice – even if the appliance is still under
guarantee!
Fault
Temperature differs greatly
from the set value.
Appliance has no
refrigeration capacity.
The light does not work.
The display does not
illuminate.
Warning signal is emitted.
The temperature display
flashes.Fig. $/1
The temperature in the
freezer section is too warm.
18
Possible cause
Power failure.
The fuse has been switched
off.
The mains plug has not been
inserted properly.
Appliance is open.
Fault - the freezer
compartment is too warm.
Frozen food is at risk.
Ventilation openings are
covered up.
Too much food was placed in
the freezer at once.
Appliance opened
frequently.
The ventilation openings
have been covered.
Large quantities of fresh
food are being frozen.
Remedial action
In some cases it is adequate to switch off
the appliance for 5 minutes.
If the temperature is too high wait a few hours
and check whether the temperature has
approached the set value.
If the temperature is too low check
the temperature again the next day.
Check whether the power is on.
Check the fuse.
Check whether the mains plug is secure.
Close the appliance.
To stop the temperature display flashing, press
temperature setting button. Press Fig. $/3.
The temperature display will also stop flashing
when the freezer section is cold enough again.
Ensure that there is adequate ventilation.
Do not exceed the freezing capacity.
Do not open the appliance unnecessarily.
Remove obstructions.
Do not exceed the freezing capacity.
Advertisement
Table of Contents
