Yamaha R7 2024 Owner's Manual page 26

Instrument and control functions
 "AVE_ _._ MPG": the average dis-
tance that can be traveled on 1.0
US gal of fuel.
TIP
 To reset the display, change the
display to the average fuel con-
sumption display, and hold the
4
"RES" switch until it is reset.
 After resetting, "- -.-" is shown un-
til the vehicle has traveled some
distance.
Coolant temperature display
1
1. Coolant temperature display
This display shows the coolant tem-
perature from 104 °F to 241 °F in 1 °F
increments.
If the message "HI" flashes, stop the
vehicle, then stop the engine, and let it
cool. (See page 7-38.)
TIP
 When the coolant temperature is
below 104 °F, "Lo" will be dis-
played.
 The coolant temperature varies
with changes in the weather and
engine load.
Air temperature display
EAU93060
1. Air temperature display
This display shows the air temperature
from 16 °F to 122 °F in 1 °F increments.
The temperature displayed may vary
from the actual ambient temperature.
TIP
When the temperature is over 122 °F or
below 16 °F, "_ _" will be displayed.
Display brightness and shift timing
indicator light settings mode
The following settings can be adjusted
in order:
 Display brightness
 Shift timing indicator light ON /
EAU93072
 Shift timing indicator light ON
 Shift timing indicator light OFF
 Shift timing indicator light bright-
To access the settings mode
1. Turn the vehicle off.
2. Hold the "SEL" switch, turn the
1
3. Use the "RES" switch to change
4-8
FLASH / OFF
r/min
r/min
ness
vehicle on and continue holding
the "SEL" switch until the display
changes to the display brightness
control mode.
the setting values.
EAU93241