Configure Trunk (Only For Certain Devices) - TP-Link Omada EAP773 User Manual

4.6 Configure Trunk
The trunk function can bundle multiple Ethernet links into a logical link to increase
bandwidth and improve network reliability.
To configure the trunk function, go to the Management > Trunk page.
Enable
Mode
(Only for Certain Devices)
Check the box to enable the function.
Select the trunk algorithm mode. Based on the selected algorithm
mode, the AP determines which physical port is used to send out the
received packet.
SRC MAC+DST MAC: The AP determines the outgoing port based on
both the source and destination MAC addresses of the packet.
DST MAC: The AP determines the outgoing port based on the
destination MAC address of the packet.
SRC MAC: The AP determines the outgoing port based on the source
MAC address of the packet.
89