Candy CSOW 4963TWCE-80 Manual page 18

For safety reasons, in some wash
cycle phases, the door can be opened
only if the level of the water is below
its lower edge and if the temperature
is less than 45°C. If these conditions
are met, wait for the DOOR LOCKED
light to switch off before opening the
door.
l
Press the START/PAUSE button again to
re-start the programme from the point it
had been paused at.
CANCELLING THE SET PROGRAMME
l
To cancel the programme, set the
selector to the OFF position.
l
Wait until the DOOR LOCKED light has
gone out before opening the door.
DELAY START button
l
This button allows you to pre-programme
the wash cycle to delay the start of the
cycle for up to 24 hours.
l
To delay the start use the following
procedure:
- Select the required programme.
- Press the button once to activate the
delay start and then press it again (or
hold it) to set the desired delay. The
delay increases each time the button is
pressed up to 24 hours, at which point
pressing the button again will reset the
delay start to zero.
- Confirm by pressing the START/PAUSE
button. The delay countdown will begin
and when it has finished the programme
will start automatically.
l
It is possible to cancel the delay start by
turning the programme selector to OFF.
If there is a break in the power supply
whilst the machine is operating, when
the power is restored, the machine will
restart from the beginning of the phase it
was in when the power was lost.
The option buttons should be selected
before pressing the START/PAUSE
button. If an option is selected that is
not compatible with the selected
programme then the option indicator
light first flashes and then goes off.
DRYING SELECTION/STEAM
button
This button allows you:
- Automatic washing/drying cycle
After the selection of washing programme
according to laundry type, select a degree
of dryness by pressing this button. At the
end of the washing programme, the
selected drying cycle will start automatically.
If a washing programme is not compatible
with automatic drying is selected, this
function will not be activated.
If you exceed the maximum dryable load
of laundry indicated in the programme
table, the laundry may not be dried
satisfactory.
- To only perform a drying cycle
Select the desired drying programme
in conjunction with your fabrics, by
pressing this button it is possible to
select a degree of dryness that is
different to the default one (except for
the wool drying programme).
When the display
programme is finished and the DOOR
LOCKED indicator light has gone out, the
door can be opened.
IN SOME MODELS, this button is combined
with the STEAM function
- STEAM
l
By this option you can add a specific
steam treatment to some washing cycles
(see programme table).
18
shows that the
: