Install Relay Wiring Harness - Dometic Seastar JackPlate Installation And Owner's Manual

CAUTION
Before operating the Jackplate,
check mounting bolt clearances
and ensure that shift and throttle
cables, electrical lines, tiebars,
fuel hoses, and all other equipment
are clear of the Jackplate so they
will not be pinched or kinked when
the unit is moved up and down.
Figure 9. Relay Wiring Harness installation and connections.
CAUTION
Ensure the harness has proper
strain relief and is routed to avoid
damage/pinching/chafing.
10

2.3 Install Relay Wiring Harness

1. Find a dry and accessible place to mount the Relay Wiring
Harness. Use the mounting holes on the relay brackets to
secure the harness to the boat.
RELAY WIRING
HARNESS
2. Attach the ring terminal from the circuit breaker to a 12V
positive (+) post on the outboard engine battery.
3. Attach the black ring terminal to a negative (-) post on the
same battery as step 2.
CONNECT TO
BATTERY (–)
CONNECT TO
BATTERY (+)
Figure 10. Battery connections.
MOUNTING
PANEL
RELAYS MUST BE
ATTACHED TO DRY
COMPARTMENT IN
REAR OF BOAT
RELAY WIRING
HARNESS
SWITCH
LEADS
RING TERMINAL (–)
MOUNTING
HOLES
2 X JACK PLATE
RELAY
2 X MOUNTING SCREWS
(NOT SUPPLIED)
ACTUATOR
CONNECTOR
CIRCUIT BREAKER ( + )