Mount Outboard To Jackplate - Dometic Seastar JackPlate Installation And Owner's Manual

NOTICE
Jackplate position can be extended
or retracted during installation to
improve tool access to mounting
hardware.
WARNING
CRUSH HAZARD. Moving Jack-
plate parts can crush. Keep all
body parts free and clear when
actuating the Jackplate.
WARNING
All engine mounting hardware
must conform to the standards
specified in Section 2.1.
WARNING
For SeaStar Standard Duty Jack-
plates the MAXIMUM supported
horsepower is 300 HP.
For SeaStar Xtreme Jackplates the
MAXIMUM supported horsepower
is 400 HP.
CAUTION

2.5 Mount Outboard to Jackplate

1. Using an appropriate hoist and lifting eye, lift the outboard
into place.
2. Select the hole set on your outboard engine that will best suit
the boat and application.
3. Move the engine forward on the hoist while feeding the bolts
into the mounting holes.
4. Install the washers and nuts and tighten. Ensure approved bolts,
nuts and washers are used. See Section 2.1.
5. Using a torque wrench, tighten to 90 ft-lbs. (122 Nm) or to
engine manufacturer's recommended value for installation
on Jackplate.
Figure 14. Outboard installation.
Perform the Clearance Checks prior to water testing. See Section 2.6.
WASHER
(NOT SUPPLIED)
NUT
(NOT SUPPLIED)
13