Vizualogic HindSight C-1000 Install Manual

VIZUALOGIC
AUDIO R AUDIO L
To
Monitor
OUTPUT
AUDIO R AUDIO L
Monitor Functions:
1. Switch the monitor to A/V (1)
No picture will be displayed while driving
Once the car is put in reverse, the screen will
switch over to A/V (2) to display the camera view.
2. Switch the monitor to A/V (2)
The monitor will always display the camera view.
(Driving forward, or backing up)
Optional Circuit Diagram
1. Adding a relay so the Monitor will turn on when the car
is in reverse only. The Monitor will turn off when the car
goes out of reverse.
2. Relay wires
a. Connect pin 87 to the 'RED WIRE' from A/V Box.
b. Connect pin 86 to the 'ORANGE WIRE' from A/V box.
c. Connect pin 85 to GROUND
d. Connect pin 70 to the +12V Switch
e. Pin 87a is not used.
HindSight ™
3.5 INCH TFT LCD COLOR VISION
BACKUP MONITOR
SENSOR <VOL MODE VOL> POWER
AUDIO R AUDIO L
INPUT 2
2CH A/V CONTROLLER
INPUT INPUT
VIDEO VIDEO 1 VIDEO 2

System Diagram

+12V Ignition
Battery
Ground
Ground
A/V box ground
input
A/V box +12V
input
Ground
+12V Ignition
-
+
BATTERY
(GROUND) BLACK WIRE
(+12V SWITCH) RED WIRE
(+12V REVERSE WIRE) ORANGE WIRE
CAMERA
LOCATED IN THE BUMPER
REVERSE LIGHT FOUND
AT THE BACK OF THE CAR
Optional Circuit
see bottom for details
70
86
85
87a
87
Reverse wire
Tap/Connect
LENS to existing reverse
wire.
99-8019-005 10/03