Electrolux ESZ89400UX User Manual page 11

• Activation or deactivation of the
AirDry.
As the appliance stores the saved
settings, there is no need to configure
it before every cycle.
How to set the programme
selection mode
The appliance is in programme selection
mode when the programme indicator
is on and the display shows the
programme duration.
After activation, the appliance is in
programme selection mode by default. If
not, set the programme selection mode
the following way:
Press and hold simultaneously
until the appliance is in programme
selection mode.
How to enter user mode
Make sure the appliance is in
programme selection mode.
Water hardness
German de‐ French de‐
grees (°dH) grees (°fH)
47 - 50 84 - 90
43 - 46 76 - 83
37 - 42 65 - 75
29 - 36 51 - 64
23 - 28 40 - 50
19 - 22 33 - 39
15 - 18 26 - 32
11 - 14 19 - 25
4 - 10 7 - 18
<4 <7
1) Factory setting.
2) Do not use salt at this level.
Regardless of the type of detergent
used, set the proper water hardness
To enter user mode, press and hold
simultaneously
indicators
flash and the display is blank.
7.2 The water softener
The water softener removes minerals
from the water supply, which would have
a negative effect on the washing results
and on the appliance.
The higher the content of these minerals,
the harder your water is. Water hardness
is measured in equivalent scales.
The water softener should be adjusted
according to the hardness of the water in
your area. Your local water authority can
advise you on the hardness of the water
in your area. Set the right level of the
and
water softener to assure good washing
results.
mmol/l mg/l (ppm)
8.4 - 9.0 835 - 904
7.6 - 8.3 755 - 834
6.5 - 7.5 645 - 754
5.1 - 6.4 505 - 644
4.0 - 5.0 395 - 504
3.3 - 3.9 325 - 394
2.6 - 3.2 255 - 324
1.9 - 2.5 185 - 254
0.7 - 1.8 70 - 184
<0.7 <70
level to keep the salt refill indicator
active.
ENGLISH
and until the
, and
Clarke Water soften‐
degrees er level
58 - 63 10
53 - 57 9
46 - 52 8
36 - 45 7
28 - 35 6
23 - 27
1)
5
18 - 22 4
13 - 17 3
5 - 12 2
< 5
2)
1
11