Table of Contents
Advertisement
INSTALLATION
If your service provider or antenna installer has already installed your TV system to receive terrestrial TV and Analog Cable
TV, services do not change any of the connections of those devices or installation settings unless it's absolutely necessary.
If your receiver has not been configured by your service provider or system installer, then it will not be set up for any
specific channel or frequency when powered on for the first time.
● Initial Screen –
The first time the receiver is powered on, it will
display the asic "MENU" and background.
● Use the arrow keys
▼▲ to move through
the menu, the SELECT button to choose specific
item, and EXIT button to return to the main menu
from submenus or leave the main menu.
AUTO SCAN
The steps required to automatically program the receiver
are outlined as below:
● Select "INSTALLATION" and enter into
Installation page.
● Select the "AUTO SCAN" to start automatic
scanning function
● The receiver starts scanning from channel 2 to
channel 69. The percentage bar shows the progress
being made.
● Once the digital TV signal is scanned, the channel
number and program name will be shown on the
Program List above the percentage bar.
● It takes about four minutes to complete the whole
scanning process.
● Scanning will end up on channel 69,when it is
complete you can press "exit" key to leave this
window and enjoy watching DTV programs.
10
Advertisement
Table of Contents
