Connecting To Audio Video Devices - Vizio BRAVO HD1 User Manual

High definition television receiver
Table of Contents

Advertisement

CONNECTING TO AUDIO VIDEO DEVICES

Physical Installation
There are many ways to connect the terrestrial receiver to your home entertainment system, depending on the
equipment and connection types you have. However, for the best video/audio quality, use the higher quality
Y/Pr/Pr or S-Video connections if available. And always remember to disconnect the the receiver from the power
source prior to connecting or after disconnecting the cable to the UHF/VHF antenna
Video Cable Types
RF connector and coaxial cable – provides good picture and mono sound.
If you connect the Off – Air broadcast to the receiver, you must use the RF
connector for the signal input.
Audio/Video (RCA) connector and cables – provide better picture quality and
stereo sound. These cables are commonly grouped with three connectors on
both ends, and are color coded as yellow –video signal, white – left signal,
and red – right audio signal.
S-Video (super-video) connector and cable – provides even better picture
quality – When using this cable type, you still need to use the RCA audio
connection(s) for sound.
SPDIF connector (Fiber Optic) – deliver on decoded audio AC-3 signal
to your sound amplifier.
Notes:
(a) If your TV Display supports 1080i / 720p / 480p / 480i video input formats, please use the receiver's Y/Pb/Pr
video output connectors to connect with the TV Display
Then use the FORMAT key on the remote control to switch between four video output formats 1080i / 720p /
480p / 480i
(b) If your TV Display supports 480p/ 480i video input formats, you can also follow (a) above for connection
(c) If your TV Display supports 480i video input format, please use the receiver's S-VIDEO or VIDEO output
connectors to connect with the TV Display
Before Connecting to other devices
!
When the receiver is connected to the antenna attached with a signal amplifier which requires
power supply, be sure the amplifier doesn't have power leakage before connecting the coaxial cable to
the receiver. You can find connections between the receiver and all the related devices in graphics on
the next page.
7

Advertisement

Table of Contents
loading

Table of Contents