Engine Speed Adjustment - Echo PB-5810 H/T Quick Start Manual

Engine Speed Adjustment

NOTICE
To avoid engine damage due to over-revving, do not block blower pipe.
• Allow the engine to warm up for a few minutes.
• Set engine speed with throttle position
lever (A).
PB-9010T
Control engine speed with throttle
trigger (B), or for continuous use, set
engine speed with throttle position lever
(A).
• Use lower speed to blow dry leaves from
walks, patios and drives. Use rakes and
brooms to loosen debris before blowing.
• Additional speed may be necessary to
clean grass and leaves from a lawn or
flower bed.
• Higher speed may be necessary to
move gravel, dirt, snow, bottles or cans
from a driveway, street, parking lot or
stadium.
• Always stop unit using stop engine
procedure.
Note: Never use a higher speed setting
than necessary to perform a task.
Remember, the higher the engine speed, the louder the blower noise.
Adjust Harness
1. Pull straps (C) downward to adjust
shoulder harness.
2. Adjust harness limiter strap (D) for
comfortable operation.
© 02/2024 ECHO Incorporated X7151210000
Quick Start Guide / Guía de inicio rápido / Guide de démarrage rapide
PB-5810 H/T
A
PB-5810 H
A
PB-5810 T
B
D
C
C
For Operator comfort in Cold Weather Operation
WARNING
This product should not be used in temperatures below 15° F (-9° C)
otherwise damage to the fuel lines may occur.
1. Remove clips from back cushion.
Remove back cushion (A) from frame.
2. Install cold weather insert (B) on
frame over air intake.
3. Install back cushion (A) to frame over
cold weather insert.
Note: Blower performance may be
reduced slightly.
A
B
A
13