Audio Input And Output Connections; Balanced Input Connections - Sanway Audio HT-10Q Manual

SANWAY AUDIO
Audio input and output connections

BALANCED INPUT CONNECTIONS

Audio input-4-channel models
Unbalanced Input connections
Speakon Output connections
Refer to the instructions in this section if your amplifier is equipped with the Speakon output connectors
Speakon outputs-4-channel models
When linking the same source signal to several input channels, be aware that there
is a limit to the number of channels an output source can "drive". A typical output
sourse (e.g. a DSP crossover unit) can drive up to four amplifier channels before
external line-drivers might be required to buffer the signal.
http://www.china-sanway.com http://www.china-sanway.com
The XLR input connectors are electronically balanced,
and wired according to the IEC 268 standard ( pin 2=
hot ). XLR input connectors should be wired follows:
Pin 1 Ground/Shield
Pin 2 Hot (+)
Pin 3 Cold (-)
To connect an input to an unbalanced source, it is
possible to connect pins 1 and 3 in the XLR plug at the
amplifier end of the cable. However, a better method
is to connect pin 3 to the shield at the source end of the
cable, as this usually results in better hum and noise
rejection. Balanced input connections are recommended
whenever possible
6