CYBEX 12120-999-4 L Owner's Manual page 11

If
If machine needs
weight stacks
removed before
moving to desired
location.
Move to machine to the desired location
1. Remove the four shipping cones using a 3/4" socket or wrench.
2. Attach foot pads to each foot of frame.
Securely anchor machine to the floor
Cybex strongly recommends to maximize stability, equipment must be secured to a solid level
surface.
WARNING: Anchoring equipment:
Cybex is not responsible for the actual anchoring of equipment. Consult with a
•
professional contractor.
Use fasteners having a minimum of 500 lbs. tensile capacity (3/8'' grade 2 bolts or
•
better).
If legs/frame does not contact surface, DO NOT pull down with anchors. Shim
•
any leg or frame not in contact with surface using flat washers.
Install weight plates
1. Install individual weight plates one at at time.
2. Position each weight plate so wide edges of bushings face upward and narrow edges of
bushings face downward.
Wide bushing
edge faces upward
Cybex Owner's Manual
7. Slowly release grasp of guide rod cap.
8. Guide rod cap contains a compression spring that will fly if grasp
is not released slowly.
9. Remove
guide rod cap and spring and set aside.
10. Repeat above steps for opposite guide rod.
11. Lean guide rods slightly outward, away from machine to clear
pulley. DO NOT put excessive pressure on guide rods, it will
damage rod caps
12. Slide top weight up and out of the machine and set aside.
11
Then
The narrow bushing edge
must face downward.