Table of Contents
Advertisement
WARNING! The intra-building port(s) of the equipment or subassembly is suitable for connection to intra-building or
unexposed wiring or cabling only. The intra-building port(s) of the equipment or subassembly MUST NOT be metallically
connected to the interfaces that connect to the OSP or its wiring. These interfaces are designed for use as intra-building
interfaces only (Type 2 or Type 4 ports as described in GR-1089-CORE, Revision 4) and require isolation from the exposed
OSP cabling. The addition of Primary Protectors is not sufficient protection in order to connect these interfaces metallically
to OSP wiring.
The intra-building port (RJ-45) of the equipment or subassembly must use shielded intra-building cabling/wiring that is
grounded at both ends.
Default IB4 Ethernet Port Parameters
IPv4
IP Address:
192.168.1.2
Subnet Mask:
255.255.255.0
Default Gateway: 192.168.1.1
Figure 5.12 IB4 Board Ethernet Port (to connect Local Area Network [LAN])
584130100 List 01 Shown.
Other Configurations Similar.
(Factory connected to NCU
Controller backplane.)
IPv6
IPv6 Address:
IPv6 Prefix:
IPv6 Gateway:
USB-B Port
IB4 Board
Proprietary and Confidential © 2023 Vertiv Group Corp.
Vertiv™ NetSure™ Inverter System Installation Manual
20fa:fffd:fffc:fffb:fffa:fff9:fff8:fff7
0
20fa:1:fffe:ffff:fffe:fffd:ffff:fffe
Rear
Rear Panel Removed
in Illustration
USB-A Port
(not used)
10M Ethernet Port (RJ-45)
(to connect to Local Area Network)
29
Advertisement
Table of Contents
