Advertisement
SL-J110R
Mi REPLACEMENT
PARTS LIST
Pi
SPSB6I
PAD(OUST COVER)
PI
SPGB185
CARTON BOX
P12
SPSB58
PROTECTION SHEET
(E, EK, XL. EG)
ACCESSORIES
(EB. EH, El)
Al
(XA)
(E, EB, EH)
Al
SQX54662
INSTRUCT | ON MANUAL
SQXLJIOOR-KE
INSTRUCTION MANUAL
SBGB186
CARTON BOX
SPSBH0-2
PAD(FRONT)
SQX54664
INSTRUCT [ON MANUAL
P3
SPSB31-1
PAD(REAR)
P4
SFHKNOSNO1
CLAMPER
SQ.X54665
INSTRUCT ION MANUAL
PS
SPEBS
CLAMPER
PG
SFHSNOSNOTE
§ SPACER, DUST COVER
SO.X54666
INSTRUCT [ON MANUAL
P7
SPHBS
PROTECT ION SHEET
P8
XZBSOX60A01
PROTECTION COVER
A
RJP120ZBS-H
AC PLUG ADAPTOR
Pg
SFYF32B35
—«- P-BAG
SFHDCOINO1
PAD
SJUP2257T
CORD
AUTO-START POSITION
_ Clamp tonearm at the rest position. Lightly tap tonearm to make sure it is
securely clamped in place.
. Remove the dust cover.
_ If tonearm sets down outside of record's lead-in groove, turn clockwise (IN).
If it sets down to the far inside lead-in groove, turn counterclockwise (OUT).
Note: Do not push down very strongly on screwdriver.
4. Replace dust cover.
TONEARM LIFT HEIGHT
. Remove the dust cover.
. Secure the tonearm with arm clamper.
. Set the cueing contro! switch to "VW".
_ Put a record on the turntable mat.
Screwdriver
_ Shift the arm clamper to set the tonearm free,
and adjust the gap between stylus tip and record
surface to 4mm~/7mm.
ROTATING SPEED
1. Set the speed selector switch to 33".
2. Raise the unit and insert a screwdriver into the adjusting hole (33-rpm)
from the back to turn VR101.
3. Set the speed selector switch to 45".
4. Same as in step 2, insert a screwdriver into the adjusting hole (45-rpm)
and turn VR102.
Rotating speed
AUTO-RETURN POSITION
1. Clamp the tonearm at the rest position.
2. Raise
the
unit
and
insert
a screwdriver
into
the
adjusting hole from the back to turn the adjustment
screw.
If the tonearm
returns before the tune ends...... Turn
i
clockwise.
Auto-return position
If there is no auto-return..... Turn counterclockwise.
adjustment
So 137
Advertisement
