Display Setup - JVC LV-N402 Instruction Manual

Display setup

I can't select the predetermined resolution.
Check the followings:
• Was the monitor connected when the computer was turned on? Start up the
computer with the monitor being connected.
• Isn't "Hide modes that this display cannot display" unchecked? Select
Display Properties>Settings(tab), select the subject display's icon, click
Advanced>Monitor(tab), and uncheck "Hide modes that this display cannot
display."
• Isn't the old driver active? Uninstall the driver first and then install the new driver.
• Is there a display icon that has
display.
Is there any other way to change the display settings?
The settings can be made in the Display Properties by right-clicking on the desktop.
Tell me about the multi-display mode settings.
See Chapter 5.
Nothing comes up on one of four monitors connected to this card.
Check if the display's multi-display setting is not in "Single display" and if the
display is "Attached" by right-clicking the display icon in Display Properties. Check
"Attached" if not.
I can't open the Monitor tab in Display Properties>Settings>Advanced.
Open Device Manager, delete the display icon with
Is it possible to have the portrait orientation using the NVRotate function and by
setting a portrait resolution in Display Properties simultaneously?
Yes. However, if a non-NVIDIA card coexists, a Control Panel error may occur.
Even if I rotate the orientation using NVRotate, the display icon in Display
Properties>Settings doesn't rotate.
Close Display Properties once and open it up. The icon should be rotated.
What are the display types that may be listed in the Display drop-down menu in
Display Properties>Settings?
Plug and Play Monitor, Multiple Monitors, and Default Monitor depending on the
system configuration.
ENGLISH
mark in Device Manager? If so, delete the
- 30 -
mark, if any.