Using The Sleep Timer.29 - Panasonic SC-AK20 Operating Instructions Manual

Using the sleep timer
To switch the timer OFF:
Press ©PLAY/0REC and check "©REC" goes out.
If you set the timer wrongly
Press ©PLAY/®REC so that "®REC" goes out. Then, repeat the
procedure from step 1.
To check settings
Press CLOCK/TIMER to select "®REC".
Two seconds later, the display will change in the following order.
0 Recording start time
0 Recording over time
0 Recording source
You can check settings even when power is OFF.
To enjoy the desired source after the timer setting Is completed.
Even if you change the music source, the timer recording will start
with the preset condition,
1. Following step 6, turn ON the power and start playing the desired
source.
2. Press POWER to standby mode after enjoying the play, and
confirm a tape is inserted in deck 2.
Turning the timer ON/OFF
As long as "®REC" is displayed, the record timer will come ON
everyday as set.
You can turn the timer ON/OFF by pressing "©PLAY/OREC" while
power is OFF.
Remember that when "®REC" is displayed, the timer is ON. When
not displayed, the timer is OFF.
CTfH
• If the power is ON, the timer will not function. The system must
be in the standby mode.
• If you switch the power to the standby mode while the record timer
is functioning, the OFF time setting will not be activated.
• If AUX is selected as the source, when the timer comes ON, the
system will turn ON, will engage "AUX" as the source and will start
recording. If you want to record from the cormected component,
set the component's timer to the same time. (See the instruction
manual that came with the component.)
by remote control only
• Make sure that you have completed "Setting the time" on page 9.
• Switch on the power.
The following example in the figure shows how to set the system to
standby mode after 30 minutes.
While enjoying the desired source:
Press SLEEP to select the desired time.
n
Every time you press the button;
p* 30 60 — 90 — 120 — OFF-1
The system is turned off after the set time has elapsed.
To cancel the sleep timer:
Press SLEEP to select "OFF".
To confirm the remaining time:
(only while power is ON)
Press SLEEP.
To change the time remaining during operation:
Press SLEEP to show the remaining time then press SLEEP to select
the desired time.
The sleep timer turns OFF automatically the moment you attempt
to record a CD using CD Manager function.