Installation; General Information - Hayward SwimClear C2030 Owner's Manual

Your Hayward SwimClear
corrosion-resistant construction. With filtration ratings to 9000 gallons (34,000 liters) per hour, they are
designed for continuous or intermittent operation, for installation above or below the pool water line, for fresh
or salt water swimming pools or spas. SwimClear™ filters utilize multiple reusable, reinforced polyester filter
cartridge elements to provide a high degree of water clarity and long filter cycles with minimum care.
C2030
C3030
C4030
C5030
C7030

INSTALLATION

B
6. Connect the pump discharge (pump OUTLET) to the top port of the filter (filter INLET).
7. Connect the bottom filter port (filter OUTLET) to the pool return plumbing lines.
8. Do not locate pump controls over or near filter.
9. Verify water discharge from the manual air relief valve(MAR) is directed away from electrical devices.
Page 4 of 12

GENERAL INFORMATION

TM cartridge filter combines superior water filtration with ease of operation and totally
A
IN CM
32.5 83
34.5 88
40.5 103
46.5 118
52.5 133
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
SWIMCLEAR™ CARTRIDGE FILTER
REQUIRED CLEARANCE
"B" SIDE "C" ABOVE
IN CM IN
18 46 15
18 46 16
18 46 18
18 46 22
18 46 28
WARNING
This product should be installed and
serviced only by a qualified pool
professional.
1. The filter system should be
installed on a level concrete slab or
other rigid base. Select a well
drained and vented area, one that
does not flood when it rains.
Position the filter so that the piping
connections, and winter drain are
convenient and accessible for
operation, service, maintenance
and winterizing.
2. Position filter body such that all
operation and safety labels are
visible.
3. Position filter so the filter will drain
by gravity.
4. If practical, place pump and filter in
the shade to shield it from
continuous, direct heat from the
sun.
5. Connect the pool suction plumbing
between the skimmer, pool suction
outlet (from the pool) and the
pump.
CM
38
41
46
56
71
ISC2031 REV B