Red Arrow VAN/3 Installation Instructions

Safety Warning
•
The installation should be carried out
by a qualified electrician in compliance
with the current edition of the IEE
Wiring Regulations.
•
Prior to installation, carry out the
necessary risk assessment considering
the people who could be at risk,
the level of risk and the precautions
required to control the risk
•
Ensure that the circuit supply is
isolated either by the circuit supply
fuse being removed or the applicable
Specification
Box Contents -
1 x Maintained/Non-Maintained 230V Emergency Bulkhead, /ST Version
with Self Test Functionality
1x Self-Adhesive Exit Legend
Dimensions: L: 351 x W: 111 x D: 63mm
Body: ABS
Material:
Lens: Polycarbonate
Colour
6500K
Temperature:
LED Lifetime:
L70B50 36,000 Hrs
IP Rating: IP65
IK Rating: IK06
Working
0°C to 45°C
Temperature:
Guarantee:
5 Years
5
3
YRS
WATT
GUARANTEE
Installation Instructions
1. Isolate the mains supply before carrying out any installation or maintenance work.
2.
Remove the diffuser/lens from the fitting by loosening the screws at either end.
3.
Access the terminal block & batteries by pushing the 2 retaining clips outwards and rotate the gear tray on its hinge as shown.
2
INSTALLATION INSTRUCTIONS
Vanguard Emergency Bulkhead (/ST Version with Self Test)
Product Codes: VAN/3 & VAN/3/ST
IP65
6500K
circuit breaker being turned off before
installation or any maintenance.
•
Check the total load on the circuit
ensuring the luminaire does not exceed
the rating of the circuit cable, fuse or
circuit breaker.
•
Long-term use and voltage fluctuations
can reduce the life span of the fitting.
•
If the fitting incorporates control gear,
ensure careful sizing to avoid instances
of nuisance tripping of the protective
device used in the installation.
LED
230V
3
•
Follow the provided installation
instructions, using the fixings supplied
or recommended.
•
Keep out of reach of children.
L351mm
SELF TEST
(Self Test Version Only)