Red Arrow POLO 15W LED Installation Instructions Manual

POLO 15W LED
Emergency Bulkhead with
Microwave Sensor
Installation Instructions p.1
For models: POL15LEDEMS
This installation must be carried out by an electrician.
Please read these instructions carefully before installation.
Leave a copy for the user/maintenance engineer for future reference.

Specification

• 220-240V
• 15W
• 66pcs of 2835 LED
• 1100 Lumen output / 90lm in emergency mode
• 30,000 Hours life expectancy
• 4000K Colour temperature
• Three years guarantee
• Dimensions: Ø: 326 x D: 108mm

Description of Microwave Sensor

• The microwave sensor option offers presence
detection to provide automatic control of lighting
loads. It is installed inside the luminaire so does
not affect external aesthetics or the IP Rating.
Manual adjustments on the sensor allow it to be
individually tailored to suit your application.

Safety

• This is a mains powered product. It is designed to be
installed by a qualified electrician and in accordance
with the applicable building and electrical
regulations. Before installation or maintenance the
electrical supply to the product must be isolated.
Installation Instructions
• Remove the diffuser & trim from the base by rotating anti-
clockwise to unlatch then pull away.
• Loosen the three gear tray retaining screws, rotate the gear
tray anti-clockwise to align the screw heads with the large
aperture of the keyhole slots & remove the gear tray
away from the base. There is a retaining strap to assist with
installation.
• Prepare the mains supply cable & fixing points on the chosen
mounting surface ensuring it is able to retain the weight of
the luminaire.
Red Arrow Trading
Elsworth House, Herries Road South, Sheffield, S6 1QS
• Pass the mains supply cable through the hole & grommet
provided in the base, position the base to the mounting
surface & secure using the screws provided.
• It is the installer's responsibility to ensure the fixing points
& cable entry point are appropriately sealed to maintain
the IP54 rating. Silicone bathroom sealant or equivalent is
recommended.
• Route the mains supply cable to the terminal block on the
gear tray & terminate ensuring correct polarity is observed.
WARNING: THIS LUMINAIRE MUST BE EARTHED.
It is important that supply cables fitted to luminaires with an
electronic ballast do not run adjacent to leads connected to
the ballast output terminals so as not to affect radio
frequency interference suppression.
• Secure the supply cable using the clamp provided in the base.
• Refit the gear tray & secure by retightening the screws.
• Refit the diffuser & trim by placing over the base & rotating
clockwise until it locks into position.
• Reconnect power supply & check for correct operation.
Luminaires fitted with electronic ballasts are exempt from
insulation resistance tests as this may cause damage to the
ballast.
Further Instructions for Emergency
version
• In addition to the above instructions, a secondary "un-
switched" live supply should be fed to the luminaire, in line
with the "switched" mains supply. This "un-switched" supply
MUST be taken from the same phase as the "switched"
supply & MUST be wired at the switchboard so that upon
test, it is isolated at the same time as the "switched" supply.
• Route to the terminal block & terminate, ensuring correct
polarity is observed.
• Connect the battery supply to the module by joining the
connectors, ensuring correct polarity is observed.
T: 0800 195 0006
E: sales@redarrowtrading.com
F: 0870 043 3946
www.redarrowtrading.com