Table of Contents
Advertisement
Available languages
Available languages
Introduction
WARNING:
maintenance, you must read and
understand the safety chapter.
For all servicing and repair work on the product, special
training is necessary. We guarantee the availability of
professional repairs and servicing. If your dealer is not
a service agent, speak to them for information about the
nearest service agent.
Do a general inspection.
Clean the product.
Examine the dethatcher equipment.
Make sure that the safety devices on the product are not defective. *
Examine the covers. *
Do a check of the motor brake handle. *
Do a check of the start inhibitor. *
To do a general inspection
•
Make sure that the nuts and screws on the product
are tightened.
•
Make sure that the cables on the product are not in a
position where they can get damaged.
•
Make sure that there is no blockage in the product.
To clean the product
•
Clean plastic parts with a clean and dry cloth.
•
Do not use water to clean the product. Water can
enter the battery or the motor and cause short circuit
or damage to the product.
•
Do not use a high pressure washer to clean the
product.
•
Do not flush water directly on the motor.
•
Use a brush to remove leaves, grass and dirt.
To examine the dethatcher equipment
WARNING:
disconnect the power cord.
WARNING:
when you do maintenance on the dethatcher
2368 - 002 -
Maintenance
Before you do
To prevent accidental start,
Use protective gloves
For more detailed information, refer to
www.husqvarna.com.
Maintenance schedule
The maintenance intervals are calculated from daily use
of the product. The intervals change if the product is not
used daily.
For maintenance identified with *, refer to
on the product on page 11 .
Each use
equipment. The tines on the dethatcher
equipment are very sharp and cuts can
easily occur.
•
Examine the dethatcher equipment for damage
or cracks. Always replace a damaged dethatcher
equipment.
To replace the dethatcher equipment
WARNING:
when you do maintenance on the dethatcher
equipment. The dethatcher equipment is
very sharp and cuts can easily occur
1. Put the product on its right side. (Fig. 36)
2. Remove the 2 screws (A) and the dethatcher cover
(B). Push the dethatcher equipment (C) up and out
to remove it. (Fig. 37)
3. Push the new dethatcher equipment (C) into the
groove and down the hole. Attach the dethatcher
cover (B) and the 2 screws (A) (Fig. 38)
Safety devices
Each
Monthly
season
X
X
X
X
X
X
X
Use protective gloves
15
Advertisement
Chapters
Table of Contents
