Table of Contents
Advertisement
Installation
Note:
Before finally installing the unit, connect
the wiring temporarily and make sure it
is all connected up properly and the unit
and the system work properly.
Use only the parts included with the
unit to ensure proper installation. The
use of unauthorized parts can cause
malfunctions.
Consult with your nearest dealer if
installation requires the drilling of holes
or other modifications of the vehicle. |
Install the unit where it does not get in
the driver's way and cannot injure the
passenger if there is a sudden stop, like
an emergency stop.
DIN Front/Rear-mount
This unit can be properly installed either
from "Front" (conventional DIN Front-
mount) or "Rear" (DIN Rear-mount
installation, utilizing threaded screw holes
at the sides of unit chassis). For details,
refer to the following illustrated installation
methods.
DIN Front-mount
Installation with the rubber bush
(Fig. 5)
Installation without the rubber bush
(Fig. 6)
1. Dashboard
2.
Holder
After inserting the holder into the dashboard,
then select the appropriate tabs according to
the thickness of the dashboard material and
bend them.
Rubber bush
Screw
Nut (5 mm)
Drill a 5.5 — 6.0 mm diameter hole.
Screw (5 x 16 mm)
Strap
'Be sure to use the strap to secure the back of
the unit in place. The strap can be bend by
hand to the desired angle.
So
Oe
oO
Fig. 5
Fig. 6
Advertisement
Table of Contents
