Lenovo RackSwitch G8296 Installation Manual page 57

Hide thumbs Also See for RackSwitch G8296:

Table of Contents

To remove a hot-swap power supply module, complete the following steps:

1. Remove the power cord from the module's power connector.

2. Press the release latch of the power supply module, and slide the module out of

the bay.

Attention: Do not leave the power-supply bay empty for more than 90 seconds

while the switch is operating. Either replace the power supply module or install a

blank power filler plate.

To return the component to customer service for replacement, see

Appendix A,

"Getting Help and Technical

Assistance" on

page 77

to help you gather all the

required information that is necessary to return a component. After you remove the

component, securely pack the component for shipping.

Chapter 4: Removing and Replacing G8296 Components

Table of Contents