Advertisement
RECHARGING THE NB-G1U BATTERY PACK
To
charge
the battery pack,
use the exclusive
AA-G10E
adapter/battery charger (AC power), No other charger, includ-
ing JVC's other models, can be used to charge the NB-G1U
battery pack.
The AA-G10E can charge 4 battery packs at a time. Two
different charging modes are available; normal charging and
quick charging. In normat charging, 4 battery packs are charged
in parallel and charging is completed in about 10 hours. in
quick charging, charging is performed one battery at a time,
taking about 90 minutes per battery pack. After the 4 battery
packs have been charged in sequence, they are charged together
in the normal charging mode for one hour.
1. Insert a battery pack into each compartment of the AA-
G10E, contacts first and with the printed side to the left,
untif it locks into place.
. Press the POWER button of the AA-G10E to ON.
. Press either the QUICK CHARGE or NORMAL CHARGE
button depending on the charging mode you select.
Wn
@
If the BR-S411E is connected to the AA-G10E, make sure
that its POWER button is OFF.
@
For more details about charging, refer to the instruction
manual for the AA-G10E.
LOADING AND UNLOADING A CASSETTE
©@ Set the POWER
button to ON and press the OPERATE
button
before
inserting a cassette.
tf the AUTO
OFF
indicator should flash, do not insert a cassette, but put the
machine in a dry place and wait until the indicator goes off.
®@ Before inserting a cassette, check to see if there is any
tape slack.
To remove the cassette, the power should be on, otherwise
the tape is not unloaded.
@
If a cassette is loaded near the end of the tape, tape loading
may not be performed and the TAPE END indicator will
remain lighted. If you wish to record onto the last few
minutes of tape, remove the cassette and rewind the tape
slightly by hand or with a tape winder.
© If the EJECT button does not function when the power is
Off, first switch on the power, then press the EJECT button.
1. Press the EJECT
button, and the cassette housing will
open gentiy. Insert a cassette correctly so that the groove of
the cassette is in line with the cassette guide of the cassette
housing.
2. Press the housing cover down by hand at the top edge.
The STOP LED will light.
CONNECTIONS
fee eee,
|
BR-S810E
Microphone
"toe
AUDIO AMPLIFIER
-10—
Earphone
Advertisement
