Advertisement
COMPREHENSIVE WARNING SYSTEM
To ensure trouble-free operation and quality recordings, the
BR-S411E
has a comprehensive array of warning indicators.
When any of the warning indicators lights or flashes, beeps
can be heard in the output sound from the EARPHONE
Jack. With some cameras, their tally lamps are controlled by
the same
warning
signal and
present
identical
indications.
The following chart summarizes
the facts relating to the
warning system.
Indication symbols:
©
: The LED remains lit.
@
=: The LEO flashes at intervals of 1 second.
@
__: The LED flashes at intervals of 1/4 second.
: Continuous warning tone is heard.
: Intermittent beep, 1-second intervals.
: Intermittent beep, 1/4-second intervals.
Alarm sound?) in the
earphone
Tally indication on
camera
Remarks
L.ED indicator
SERVO
LOCK
| Rec
nal
pase
| stops | store [ -
eee
=a |
re
ooo a
eae
prseohr| Os
BATT
1) The alarm sound is superimposed on the audio output from the EARPHONE jack.
Priority of earphone output:
'Out of lock.
About 2 minutes
before the end of the
tape.
Capstan, drum or
reel motors stop,
Slightly before the
battery is depleted.
Battery depleted.
anne
ON
YN
D> RR
OR
RO
2) If the AUTO OFF state due to condensation occurs, dry inside the recorder,
POWER SUPPLY
Power can be supptied in two ways as required.
@
To remove
the battery pack, open the battery compart-
1. Using the NB-G1U
battery pack (provided).
ment door and press the battery release button. The battery
2. Using the AA-G10E
AC
power
adapter/battery charger
pack will be released. Withdraw the battery pack.
{optional}
®@ Read the instructions on the battery pack carefully.
USING
THE
NB.G1U
BATTERY
PACK
1 mee sure that the POWER
switch
of the BR-S411E
is
FF.
2. Slide the battery compartment door latch of the battery
holder to the right and open the door.
3. Insert the NB-G1U battery pack into the battery holder
with its printed tabel to the left.
4, Close the door of the battery hotder.
USING TWO NB-.G1U BATTERY
PACKS WITH
AN
OPTIONAL
BATTERY
HOLDER
When
the BR-S411E
is used in a camcorder configuration,
'one battery pack can be installed inside the provided battery
holder and the other can be attached externaily using an
optional battery holder. Both battery packs operate in parallel
to prolong the recording time.
1. Open the cover of the DC connector pocket and pull out
the DC connector.
Combine this connector with the DC
connector
of the battery holder. Then store these con-
nectors into the pocket.
2. Mount the battery holder onto the BR-S411E and secure
with the screws. Insert a battery pack into the battery
holder.
USING THE
AA-G10E
BATTERY
CHARGER/
AC POWER
ADAPTER
1. Connect the DC OUT connector of the AA-G10E
to the
DC
IN connector
of the BR-S411£
using the DC cord
Provided with the AA-G10E.
. Connect the power cord to the AA-G10E and plug it into
an AC outlet.
. Press the VCR button on the front pane! of the AA-G10E.
. Press the POWER button of the AA-G10E to ON.
mw
Nn
{f the battery pack remains inside the battery holder, its
power is consumed even when the AA-G10E powers the re-
corder.
Be sure to remove the battery pack during AC
operation.
For more details refer to the instruction manual of the
AA-G10E,
Advertisement
