Table of Contents
Advertisement
CONTROL HUB INSTALLATION
PREPARATION
Ideally suited to being mounted up on a 4x4 canopy wall, or in a camper trailer, the control hub is best
located in an area that's easy to access and offers protection from dust and water ingress.
The unit should be mounted with consideration as to where/how you will be running your wires into/out
of the box. Make sure the box has adequate space around it to make wiring easy.
PROCESS
1.
Using a Phillips head screwdriver, remove the
four screws found on each corner of the front
face of the unit.
2.
Next, mark the mounting points on your wall/
surface. To do this, hold the box up to the
surface, and use a pen to mark the surface
through the box's pre-drilled mounting holes.
3.
Then, put the control hub down and drill through each marking on your surface. To match the box's
holes, you'll need to create a 5mm hole. Note: If mounting to a metal surface, you may need to drill
a smaller pilot hole before drilling it out.
4.
The box can now be lifted into place and secured to the wall. Thread an M5 bolt through each hole
and through the mounting surface, then fasten with suitable washers and nuts.
MOUNTING
6
Advertisement
Table of Contents
